收藏本站
LTM4607
APPLICATIONS INFORMATION
V IN ? ( V OUT(MAX) ? V IN )
V OUT(MAX) ? ? ? I OUT(MAX) ? Ripple%
orchooseacapacitorratedatahighertemperaturethan
required. Always contact the capacitor manufacturer for
derating requirements.
Output Capacitors
inductor current. In the inductor design, the worst cases
in continuous mode are considered as follows:
L BOOST ≥
In boost mode, the discontinuous current shifts from the
input to the output, so the output capacitor C OUT must be
capable of reducing the output voltage ripple.
For boost and buck modes, the steady ripple due to charg-
ing and discharging the bulk capacitance is given by:
L BUCK ≥
where:
V OUT ? ( V IN(MAX) ? V OUT )
V IN(MAX) ? ? ? I OUT(MAX) ? Ripple%
V RIPPLE,BOOST =
I OUT(MAX) ? ( V OUT ? V IN(MIN) )
C OUT ? V OUT ? ?
? is operating frequency, Hz
Ripple% is allowable inductor current ripple, %
V RIPPLE,BUCK =
V OUT ? ( V IN(MAX) ? V OUT )
8 ? L ? C OUT ? V IN(MAX) ? ? 2
V OUT(MAX) is maximum output voltage, V
V IN(MAX) is maximum input voltage, V
V OUT is output voltage, V
I OUT(MAX,BOOST) = ?
? ?
? 160mV Δ I L ? V IN
? R SENSE
2 ? V OUT
ThesteadyrippleduetothevoltagedropacrosstheESR
(effective series resistance) is given by:
V ESR,BUCK = Δ I L(MAX) ? ESR
V ESR,BOOST = I L(MAX) ? ESR
The LTM4607 is designed for low output voltage ripple.
The bulk output capacitors defined as C OUT are chosen
with low enough ESR to meet the output voltage ripple and
transient requirements. C OUT can be the low ESR tantalum
capacitor, the low ESR polymer capacitor or the ceramic
capacitor. Multiple capacitors can be placed in parallel to
meet the ESR and RMS current handling requirements.
The typical capacitance is 300μF. Additional output filtering
may be required by the system designer, if further reduc-
tion of output ripple or dynamic transient spike is required.
Table 3 shows a matrix of different output voltages and
output capacitors to minimize the voltage droop and
overshoot at a current transient.
Inductor Selection
The inductor is chiefly decided by the required ripple cur-
rent and the operating frequency. The inductor current
ripple Δ I L is typically set to 20% to 40% of the maximum
I OUT(MAX) is maximum output load current, A
The inductor should have low DC resistance to reduce the
I 2 R losses, and must be able to handle the peak inductor
current without saturation. To minimize radiated noise,
use a toroid, pot core or shielded bobbin inductor. Please
refer to Table 3 for the recommended inductors for dif-
ferent cases.
R SENSE Selection and Maximum Output Current
R SENSE is chosen based on the required inductor current.
Since the maximum inductor valley current at buck mode
is much lower than the inductor peak current at boost
mode, different sensing resistors are suggested for use
in buck and boost modes.
The current comparator threshold sets the peak of the
inductor current in boost mode and the maximum inductor
valley current in buck mode. In boost mode, the allowed
maximum average load current is:
?
where Δ I L is peak-to-peak inductor ripple current.
11
For more information www.linear.com/LTM4607
4607fc
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
LTM4608AEV#PBF IC BUCK SYNC ADJ 8A 68LGA
LTM4608IV#PBF IC DC/DC UMODULE 8A 68-LGA
LTM4609IV#PBF IC BUCK/BOOST SYNC ADJ 4A 141LGA
LTM4612IV#PBF IC BUCK SYNC ADJ 5A 133LGA
LTM4613MPV#PBF IC UMODULE DC/DC 8A 133-LGA
LTM4614IV#PBF IC UMODULE DC/DC DUAL 4A 144LGA
LTM4615IV#PBF IC SWIT REG BUCK 4A ADJ 144LGA
LTM4618IV#PBF IC DC-DC UMODULE BUCK 6A 84-LGA
相关代理商/技术参数
LTM4607IVPBF 制造商:Linear Technology 功能描述:Conv DC-DC Step Up Step Down
LTM4607IV-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:36VIN, 24VOUT High Effi ciency Buck-Boost DC/DC μModule
LTM4607V 制造商:LINER 制造商全称:Linear Technology 功能描述:36VIN, 24VOUT High Effi ciency Buck-Boost DC/DC μModule
LTM4608 制造商:LINER 制造商全称:Linear Technology 功能描述:Low VIN, 8A DC/DC μModuleTM with Tracking, Margining, and Frequency Synchronization
LTM4608_1 制造商:LINER 制造商全称:Linear Technology 功能描述:Low VIN, 8A DC/DC Module Regulator with Tracking, Margining, and Frequency Synchronization
LTM4608A 制造商:LINER 制造商全称:Linear Technology 功能描述:Low VIN, 8A DC/DC μModule with Tracking, Margining, and Frequency Synchronization
LTM4608A_1 制造商:LINER 制造商全称:Linear Technology 功能描述:Low VIN, 8A DC/DC Module Regulator with Tracking, Margining, and Frequency Synchronization
LTM4608A_12 制造商:LINER 制造商全称:Linear Technology 功能描述:Low VIN, 8A DC/DC μModule Regulator